mohammadi11
Structural
how we can connect two point in abaqus?
i want to conncect two point with same u3, just u3?
help me plz
i want to conncect two point with same u3, just u3?
help me plz
Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
How can i connect two point in abaqus?
- Thread starter mohammadi11
- Start date
- Status
aliabolhasanpoor
Civil/Environmental
you can use Connector in module interaction to connect two points in abaqus. first, you should create wire feature, second you should create section with link behavior and then assign section which previously defined to the wire feature
good luck
good luck
IceBreakerSours
Bioengineer
*Equation is a better option given what you wish to accomplish.
*********************************************************
Are you new to this forum? If so, please read these FAQs:
*********************************************************
Are you new to this forum? If so, please read these FAQs:
- Status
Similar threads
- Locked
- Question
