Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Horizontal and vertical aligning with Auto Balloon

Thread starter HAJS
Start date Apr 28, 2009

Status: Not open for further replies.

Apr 28, 2009

HAJS

Mechanical

Hello,

When I am using the function Auto Balloon in a drawing with a lot of part I find it hard to see where which Balloon goes to. Is there a kind of aligning option, for example horizontal and vertical, to get a better view. Default the ID symbol are going in every direction.

Thanks in advanced!
Henk