Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hole Parameter File (.hol)

Thread starter kwkmts
Start date Feb 23, 2009

Status: Not open for further replies.

Feb 23, 2009

kwkmts

Mechanical

I have set up a hole parameter file with my standard drill sizes. I would like to have the depths be standard as well. According to PTC the drill depth is calculated by a formula (dia *3). Is there any way this can be changed??

Any help would be appreciated.

Thanks