Hole Callout doesn't translate out to DXF or DWG: NX9

[3dr]

You get the leader but no text. I can live with it but if any one has the answer in their pocket please share! Except for this issue the translator is about perfect.

Very annoying...

TIA for any help

Dave

 

[JohnRBaker]

Are we talking about the old hole callouts created using the 'Feature Parameters' function or the new (NX 9.0) hole callouts using the Radial Dimension function?

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[3dr]

The new radial one... the old one worked descent in 8.5.

 

[JohnRBaker]

Please contact GTAC immediately and have them open a PR.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[3dr]

Thanks John, will do.

 

[JohnRBaker]

Have you tried doing a 'round-trip' test, going from NX -> DXF (or DWG) -> NX?

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[JohnRBaker]

OK, I've just verified that this problem only occurs in NX 9.0.0.19. When I tested this in NX 9.0.1.3, doing a 'round-trip' NX -> DXF (and DWG) -> NX, the Hole Callouts came through just fine. You can still go ahead and contact GTAC if you wish as there might be an MP that has been issued to address this.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.

 

[3dr]

I'll just run the update. Already downloaded from the GTAC site.

Thanks John