Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Highest Inlet Pressure for an Expander
- Thread starter RotaryG
- Start date
georgeverghese
Chemical
Perry Chem Engg Handbook 7th edn says 3000psig max inlet pressure on page 29-42. Nothing stated about flows or feed stream chem composition at this feed pressure.
Max stated permissible exit liquid content 50% by weight of total exit stream - this seems rather high.
Max stated permissible exit liquid content 50% by weight of total exit stream - this seems rather high.
georgeverghese
Chemical
If you need more info, speak to Mafi Trench, now part of Atlas Copco.
or
Rotoflow, now part of Air Products and Chemicals.
or
Rotoflow, now part of Air Products and Chemicals.
I've see up to 200 bar from standard products.
You could also check with Cryostar or Chart Industries (Purchased LA Turbine recently).
You could probably check with the original owners (Cryogenic Industries/Nikkiso), as a lot of the employees there now are ex-AC!
You could also check with Cryostar or Chart Industries (Purchased LA Turbine recently).
georgeverghese said:
You could probably check with the original owners (Cryogenic Industries/Nikkiso), as a lot of the employees there now are ex-AC!
- Status
