L
leoheart90
Guest
Hi Guys!
I have created a series of airfoils (40 sections) to model a wind turbine blade.
Using swept blend, I am able to create a surface of all the sections.
However, I am unable to create a solid model of the turbine blade. In addition, the surface created by the Swept Blend function is unable to be capped. (The model shown above has open ends)
May I know if there is any reasons behind this error?
Cheers
Leon
I have created a series of airfoils (40 sections) to model a wind turbine blade.
Using swept blend, I am able to create a surface of all the sections.
However, I am unable to create a solid model of the turbine blade. In addition, the surface created by the Swept Blend function is unable to be capped. (The model shown above has open ends)
May I know if there is any reasons behind this error?
Cheers
Leon
