We are designing water and phase-change cooling solutions for use in computers. Until evaluation of flow and efficiency is something we have done through prototyping, and therefore it would be great to find software that could help test designs before we prototype. Anyone know of good software that could be used for designing and testing such products?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Help on selecting flow computation software
- Thread starter Ocmyth
- Start date
Standing
Mechanical
- Jan 14, 2002
- 1,578
I am not sure this will work for you, but check out.
CosmosFloWorks offered by SolidWorks. We use SolidWorks and are very happy. We do not use Cosmos.
Be careful when looking into Pro-E. The cost is high, although it is a very nice package.
Bradley
CosmosFloWorks offered by SolidWorks. We use SolidWorks and are very happy. We do not use Cosmos.
Be careful when looking into Pro-E. The cost is high, although it is a very nice package.
Bradley
Ditto with Bradley. I have not used FloWorks, but we do have one seat. Something to look into. It has been used here for air temperature/flow over and around our product on an aircraft engine.
Chris
Sr. Mechanical Designer, CAD
SolidWorks 05 SP1.1 / PDMWorks 05
ctopher's home site
Chris
Sr. Mechanical Designer, CAD
SolidWorks 05 SP1.1 / PDMWorks 05
ctopher's home site
- Status
Similar threads
- Locked
- Question
