CSGWB
Mechanical
- Oct 9, 2003
- 47
I am currently trying to look at determining the correct size and frequency of expansion loops in a hot oil heat tracing system designed for 572F (300C). I have done some preliminary calculations and these calculations are indicating a requirement for a relative large loop (30in (750mm) leg at 50ft (15m) centers on both 3/4" Sch80 pipe tracing and 3/4OD 316SS tube tracing)
Does anyone have any data for expansion loops in hot oil tracing lines at similar temperatures that I could use as a reality check?
I note Thermon does have info on their Website, however it appears to be limited to steam tracing running at half the temperatue.
All assistance is appreciated.
Regards
CSGWB.
Does anyone have any data for expansion loops in hot oil tracing lines at similar temperatures that I could use as a reality check?
I note Thermon does have info on their Website, however it appears to be limited to steam tracing running at half the temperatue.
All assistance is appreciated.
Regards
CSGWB.
