Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

heat treatment- annealing

Thread starter aaron87
Start date Dec 15, 2013

Status: Not open for further replies.

Dec 15, 2013

aaron87

Industrial

hai guys,im new here..im doing researches on PEEK materials and having some problems with the annealing process..is there any SOP for composite/polymer annealing? and my material is 100mm x 50mm x 17mm, should i cut it to small pieces first before annealing or after, because i need a sample for XRD..