Hi,
For a school project I'm studying the heat dissipation of a disk rotor. Then, I choose to use Abaqus. However, it's my first step on this software. I followed many tutorials, but I have some problems. In fact, the friction forces aren't linear, the pad don't seem to be permanently in contact wish the disk rotor.
If somebody can look further to my car file, I will be rocognizant.
Regards,
Arturur
For a school project I'm studying the heat dissipation of a disk rotor. Then, I choose to use Abaqus. However, it's my first step on this software. I followed many tutorials, but I have some problems. In fact, the friction forces aren't linear, the pad don't seem to be permanently in contact wish the disk rotor.
If somebody can look further to my car file, I will be rocognizant.
Regards,
Arturur