Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hardness survey requirement to NACE MR 0175.

Thread starter express2
Start date May 26, 2017

Status: Not open for further replies.

May 26, 2017

express2

Mechanical

Dear Experts,

Please advise on below query.

Applicable codes are;
ASME Section IX
NACE MR 0175.

We have one WPS Qualified in butt joint and Hardness survey done according to NACE MR 0175 (7.3.3.3 Figure 2) on Butt weld coupon.

Is it correct that we cannot use the above WPS in a fillet joint because the fillet weld harness survey is not carried out.

Thanks
BAS