Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Grinding PTFE Coated 304 SS

Status
Not open for further replies.
FTLisa

FTLisa

Mechanical
Joined
Dec 28, 2005
Messages
1
Location
US
We flate grind the ends of PTFE coated SS wire that has been coiled into a heliz. We always have problems with strings of the PTFE hanging from the ground end. Has anyone had a simlar problem they have solved?
 
Status
Not open for further replies.

Similar threads

Tarun Tanwar
  • Locked
  • Question Question
How to flatten ss 304 sheet after perforation or punching?
Replies
6
Views
1K
EdStainless
EdStainless
SwimTsunami2
  • Locked
  • Question Question
ISO coated spring maker
Replies
5
Views
409
EdStainless
EdStainless
RanaAq
  • Locked
  • Question Question
Centreless grinding of end flat shaft
Replies
0
Views
265
RanaAq
RanaAq
Tarun Tanwar
  • Locked
  • Question Question
Can we get flat SS 316L in full hard sheet form?
Replies
1
Views
621
EdStainless
EdStainless
Ashwani Kumar
  • Locked
  • Question Question
Requirement of Diaphragm seal's PTFE & PFA coating Procedure
Replies
0
Views
150
Ashwani Kumar
Ashwani Kumar

Part and Inventory Search

Sponsor

Back
Top