Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Grafoil 2 pices of 1/8" insted one 1/4"

Status
Not open for further replies.

marceloneavez

Mechanical
Joined
Jun 6, 2012
Messages
2
Location
MX
I'm giving maintainance to a 12" 600 lbs three pice trunion valve. But where i am its complicated to find 1/4" grafoil. My doubt is can i use two pices of 1/8" instead the 1/4" . Is it posible?


 


for wahat? And with what constructional details?

...Even if this under certain circumstances perhaps could be practical possible, you will 100% sure have done something not supported by manufacturor and maintenence protocol. If you break this protocol you will lose any supplier warranty, and should ask yourself the question of who is going to bear cost and responsibillity if anything goes wrong.

Will the enduser agree and free you from any responsibillity?

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top