Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Global deformation from a text doc

Thread starter kr7530
Start date Oct 31, 2014

Status: Not open for further replies.

Oct 31, 2014

kr7530

Automotive

I have a couple of questions in regards to using Global Deformation:

If a points file is used do I still need a vector? Or does Global Deformation ignore the vector?

Is there a program out there that combines two exported AutoForm files into a text document that Global Deformation can use?

Thanks in advance,
Kevin
NX8.0