Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Generate Surface through points 1

Status
Not open for further replies.
ShaggyPE

ShaggyPE

Mechanical
Sep 8, 2003
1,127
thread559-224727

CBL,
Just wanted to say thanks. Kudos to you on this technique.

-Dustin
Professional Engineer
Certified SolidWorks Professional
Certified COSMOSWorks Designer Specialist
Certified SolidWorks Advanced Sheet Metal Specialist
 
[thumbsup2] You are very welcome ... and thank you for the "thanks". I needed a lift in spirits after the last few days I've had.

And speaking of lifting spirits ... I think I will go and lift a few. [wink]

[cheers]
 
Cheers.

-Dustin
Professional Engineer
Certified SolidWorks Professional
Certified COSMOSWorks Designer Specialist
Certified SolidWorks Advanced Sheet Metal Specialist
 
Status
Not open for further replies.

Similar threads

PEU
  • Locked
  • Question
two paths two pivot points
Replies
12
Views
8K
PEU
PEU
AminKB
  • Locked
  • Question
Surface offset issue
Replies
3
Views
373
SBaugh
SBaugh
jassco
  • Locked
  • Question
Does anyone know how to modify coordinates of points in a sketch?
Replies
1
Views
336
gb2835
gb2835
ASIT859
  • Locked
  • Question
Tube Laser Part Modeling - Normal to Surface Cuts?
Replies
10
Views
750
fraudster
fraudster
RobWard
  • Locked
  • Question
Shut off surfaces - redundant surfaces being created
Replies
0
Views
326
RobWard
RobWard

Part and Inventory Search

Sponsor

Back
Top Bottom