Jul 24, 2004 #1 macduff Mechanical Joined Dec 7, 2003 Messages 1,255 Location US How do you guys and gals cut and paste all this fancy stuff on the threads? Can we insert jpg's and gif's into the site? It would be really cool if you could. Thanks!
How do you guys and gals cut and paste all this fancy stuff on the threads? Can we insert jpg's and gif's into the site? It would be really cool if you could. Thanks!
Jul 24, 2004 #2 SBaugh Mechanical Joined Mar 6, 2001 Messages 6,691 Location US Check out the "Process TGML" below the window you type in, to reply or post. Regards, Scott Baugh, CSWP http://www.3dvisiontech.comhttp://www.scottjbaugh.com If you are in the SW Forum Check out the FAQ section To make the Best of Eng-Tips Forums FAQ731-376 Upvote 0 Downvote
Check out the "Process TGML" below the window you type in, to reply or post. Regards, Scott Baugh, CSWP http://www.3dvisiontech.comhttp://www.scottjbaugh.com If you are in the SW Forum Check out the FAQ section To make the Best of Eng-Tips Forums FAQ731-376
Jul 24, 2004 Thread starter #3 macduff Mechanical Joined Dec 7, 2003 Messages 1,255 Location US Thanks Scott! Macduff Meggitt Airdynamics Inc. Upvote 0 Downvote
Jul 26, 2004 #4 ctopher Mechanical Joined Jan 9, 2003 Messages 17,525 Location USA, CA Macduff, Missed ya at the 2005 rollout. It was cool! ctopher Upvote 0 Downvote