Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Gear shaft Heat treatment.

Thread starter fx57
Start date Nov 15, 2000

Status: Not open for further replies.

Nov 15, 2000

fx57

Mechanical

I have a layshaft on a motorcycle gearbox that I wish to drill the end to a depth of 20mm and tap M8. The shaft is hard after approx 6mm I know that to anneal the end will allow me to drill and tap it. It is the re-hardening process that I'm unsure of.Regards temperature required, cooling rate quenching methods to minimise the chance of shear/wear as this will be underneath the chain drive sprocket.
Thanks for any help.