GD&T tolerancing in NX

[lklo]

Hi --

Can anyone here explain me what´s the difference is between GD&T and GPS.
I'm jobseekers and I am asked if I have experience in GPS .
My answer is that am used to use geometric tolerance in NX , called GD&T.

Bu I am not sure ,if it is the same as GPS.

lklo

 

[cowski]

This is the first that I have heard of it, but it appears to be an ISO version/extension of GD&T.

http://www.ifgps.com/An Overview of GPS.pdf

www.nxjournaling.com

 

[lklo]

hi cowski -

thank you for your post .

you are right - gps is a further development of gd&t

in the attached pdf file , it is explained very well and precisely.

lklo

 

[cowski]

You might ask a few questions in forum1103 to get more info on the differences and how widely it is used.

www.nxjournaling.com

 

[lklo]

you are right,I´ll take a look there.

---------------

Maybee (if I´m Lucky) I will get a job at Siemnes Windpower (Denmark), as consulent from Avaloninnovation.

It´s a hughe Company - they have over the last 3 years migrated from inventor to nx ,and stil not finished.

Siemens Windpower use GPS extensively.

lklo