Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Gaps "..." in ASME Sec II Part D allowables

Status
Not open for further replies.
ashim2004

ashim2004

Mechanical
Joined
May 2, 2007
Messages
1
Location
US
I would like to know why there are gaps "..." in code allowables. For example for SA 516 Gr 70, allowables not available at 250F even though if we interpolate between 200F and 300F, it results in 20ksi.
Thanks,
Ashim.
 
Sort by date Sort by votes
the "...." means not reported.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

shiraz883
  • Locked
  • Question Question
ASME vs EN 13445| EN 12953 | Allowable stress for EN materials in ASME Sec II part D (Metric)
Replies
3
Views
907
XL83NL
XL83NL
victor6397
  • Question Question
Question about Ratcheting (ASME Sec. VIII Div.2)
Replies
6
Views
14K
victor6397
victor6397
MhmdNfri
  • Question Question
ASME Sec. I / NDT / PW-11 / Table PW-11
Replies
2
Views
524
goutam_freelance
goutam_freelance
Skatemav86
  • Locked
  • Question Question
Flange bolts preload stress: ASME II Part D vs. PCC-1
Replies
4
Views
963
TGS4
TGS4
engineer0
  • Question Question
ASME B31.8 vs 49 CFR 192 Subpart D - Design of Pipeline Components
Replies
1
Views
8K
A.egis
A.egis

Part and Inventory Search

Sponsor

Back
Top