Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations The Obturator on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Force Displacement issue with ABAQUS

Status
Not open for further replies.
Bilal803

Bilal803

Chemical
Jun 8, 2010
1
Hi

I am using ABAQUS standard to model uniaxial compaction, However, when I plot the force displacement of the upper punch the plot seems to have this plateau region. This is nopt consistent with the measure F vs D profiles that I normally get during experiemtnal measurements. I am using drucker prager cap model for my powder.

Regards

Bilal
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top Bottom