Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Home
Forums
Things
Engineering Computer Programs
Simulation
Nastran

follower traction

Thread starter srikanth1983
Start date Nov 24, 2014

Status: Not open for further replies.

Nov 24, 2014

srikanth1983

New member

i have a cantilever plate. one end of the plate is fixed and the other end has a follower traction pressure applied of 100 MPa. how do you apply follower traction in NX /? is it right to use sol 601 for this analysis ? if possible, please put screenshots. thank you.