FLOTHERM error. Can U make anything of it?

[Tunalover]

I installed my Flotherm CFD software (V2.1) and am getting an error message on startup. Can you make anything of it? Should it be cause for alarm?

&quot;ERROR E/01025-Unable to access Solution Data <possible file permission problem or file-system is full?>&quot;

Why would the code look for “Solution Data” when I hadn’t even specified a project (or built a project for that matter)? This error message came up immediately when I started my first session. It comes up whenever I open the software.

Thanks for your help!

Tunalover