Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
flat and unflat part in single view
- Thread starter Amya79
- Start date
kapmnit123
Mechanical
Ho Amya,
Is there any specific need for doing this in single view?
Regards
Kapil
Is there any specific need for doing this in single view?
Regards
Kapil
hi Amya,
Please try below procedure,(Actually I am using NX7.5,but u try in NX9)
Start>All aplications>sheet metal>forming /Flattenin>Tools>Flat pattern>Select reference face for flat pattern.
After above process your model remain same but u get flat pattern of your model which can be used in drafting.
Best regards,
Anil
Please try below procedure,(Actually I am using NX7.5,but u try in NX9)
Start>All aplications>sheet metal>forming /Flattenin>Tools>Flat pattern>Select reference face for flat pattern.
After above process your model remain same but u get flat pattern of your model which can be used in drafting.
Best regards,
Anil
- Status
Similar threads