flat and unflat part in single view

[Amya79]

Hello folks,

how to show flat and unflat part in single view (drafting)?

NX9 SHEET METAL

any answer will be apreciated.

Thanks.

 

[kapmnit123]

Ho Amya,
Is there any specific need for doing this in single view?
Regards
Kapil

 

[Anilkuber]

hi Amya,

Please try below procedure,(Actually I am using NX7.5,but u try in NX9)

Start>All aplications>sheet metal>forming /Flattenin>Tools>Flat pattern>Select reference face for flat pattern.

After above process your model remain same but u get flat pattern of your model which can be used in drafting.

Best regards,
Anil