Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

FLAC3D: State of stress not parallel to the axes

Status
Not open for further replies.
tyler_leon

tyler_leon

Civil/Environmental
Joined
Sep 7, 2018
Messages
5
Location
IT
Hi all,
I'm modelling a cavern group of FLAC3D but I have a state of stress that is not parallel to the axes. Sigma1 is rotated of about 106 degrees from horizontal.When I inizialize stresses I write "zone initialize stress xx --- yy --- zz ---".But is not correct.
Somebody can help me?

Thanks a lot
 
Status
Not open for further replies.

Similar threads

F
  • Locked
  • Question Question
How to Integrating the shear stress of the cross sectional area to find the moment M?
Replies
9
Views
6K
ThomasH
ThomasH
mrmyagi
  • Locked
  • Question Question
EN 13445-3 C.7.5 Limitation of primary stresses in case of tri-axial state of stress
Replies
1
Views
331
TGS4
TGS4
imti7
  • Locked
  • Question Question
How to find the Max capacity of the foot bracket using FEA?
Replies
9
Views
982
geesaman.d
geesaman.d
wacee
  • Locked
  • Question Question
Hot spot stress at welds
Replies
0
Views
752
wacee
wacee
netsonicyxf
  • Question Question
Add supports in the Lusas model
Replies
1
Views
3K
rb1957
rb1957

Part and Inventory Search

Sponsor

Back
Top