Fixing the camera location in FEMAP?

[jerome1]

Hello everybody,

I have a question that might be quite basic, but I wanted to know if it would be possible to "fix" the camera location. Normally, the camera rotates around a location defined by the user, but I would like to choose the camera location (for example inside a box, to be able to check the inner geometry without using any transparency).

I have tried quite many options in the view parameters, but it seems that I cannot find the one i want.

Thank you for help,

Jérôme

 

[BlasMolero]

Dear Jerome,
I don't understant very well your problem: what I use a lot is command "VIEW > ROTATE > ROTATION CENTER", this is my favorite icon to rotate the model, allows to pick in a point (set SNAP TO POINT) and the full model rotates around the coordinates of the selected point.

Your position (the observer) is always the same.

Best regards,
Blas.

~~~~~~~~~~~~~~~~~~~~~~
Blas Molero Hidalgo
Ingeniero Industrial
Director

IBERISA
48011 BILBAO (SPAIN)
WEB:

http://www.iberisa.com

Blog de FEMAP & NX Nastran:

http://iberisa.wordpress.com/

 

[jerome1]

Thank you for your reply,

Unfortunately, it did not work for me, so maybe I have an option off.
The camera rotates indeed around the point, but my issue is that I want the observer to be on the point as well, in order to keep a fixed location of the observer.
I am studying the inner part of a bone and i would like to be able to be in the center of the bone and turn the camera to obtain a 360° view of it from the inside. It would be nice if I could choose the observer location.

Best regards,

Jérôme