Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Filter Repeat Region Based on Parameter That Is NOT Always There.

  • Thread starter Thread starter maesoph
  • Start date Start date
M

maesoph

Guest
I would like to filter a repeat region based on a rule &asm.mbr.bom != NO

Where BOM is a parameter in the individual components. Of course, this is a relatively new idea so some of my older parts do not have the parameter BOM in them. I would still like to use this rule if at all possible. The default for parts without this parameter would be to include them in the repeat region... Any ideas? If exists () apparently doesn't apply to filters so that is out.
 
Perhaps use ModelCheck to place this default parameter in your older parts.
 

Part and Inventory Search

Sponsor

Back
Top