Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

fillet

Status
Not open for further replies.
medontknow

medontknow

Mechanical
Joined
Jul 15, 2002
Messages
10
Can anyone provide a tip on adding fillets to a part that will require many of them? I worked on a part recently that had several fillets. I was trying to figure out a way make the fillets easier. Some areas were very tight to reach, which required to zoom in on the edge.
 
Status
Not open for further replies.

Similar threads

hefestos
  • Locked
  • Question Question
fillet problem
Replies
1
Views
144
FH
FH

Part and Inventory Search

Sponsor

Back
Top