Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Fillet lines to curved polylines.

  • Thread starter Thread starter Beauregard
  • Start date Start date
Status
Not open for further replies.
B

Beauregard

Guest
Hi,
I want to fillet a line to curved polyline. How should it be done? I am using ACAD 2006. Any help would be greatly appreciated.
Regards.
 
Offset at fillet radius poly line and the other object then draw a circle at the fillet radius

Just a manual fillet
 
Manually fillet it

Offset both objects at the fillet raduis and draw a circle at radius at the new intersection, trim it up and there you go
 
Hi Beauregard,
Explode the polylines to arcs and then fillet that arc.
Regards.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top