IvanNX
Mechanical
- Jun 9, 2005
- 267
I have file of 2,5Mb (around 25 parts and almost 200 fastener assembly /bolt/nut/two washers on both sides/), when it is fully constrained it get to 12Mb and if I use simplification wizard on it, and just select everything and do keep clicking next (so it is just bunch of wave links in simplification) it go to over 30Mb.
Can somebody confirm that this is correct behavior or my installation is not optimized.
_____________________________
Enjoy your work and have fun!
Can somebody confirm that this is correct behavior or my installation is not optimized.
_____________________________
Enjoy your work and have fun!
