File schema in STEP file does not compute

[DanDean]

Am having difficulty importing a 100Mb STEP file from Autodesk Inventor into NX7. Getting a failure message that the schema may not be right. Where does the NX7 importer look for a schema file? Is there a better intermediate exchange format? Should I look for a direct translator? Could use a pointer to a good place to turn for expert help. Thanks in advance.

 

[JohnRBaker]

Have you tried calling GTAC?

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[cowski]

If you have been trying STEP203, try STEP214 (or vice versa).

 

[DanDean]

Thanks for the ideas. We found the problem. The file was incompletely downloaded. There was no problem with the format, schema, etc. Doh!