Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Figure UG-29.2 - ASME VIII DIV.1 1

Status
Not open for further replies.
ElCidCampeador

ElCidCampeador

Mechanical
Joined
May 14, 2015
Messages
274
Location
IT
Figure UG-29.2 - ASME VIII DIV.1.
If I have a value below the last curve Arc=0,390*Do, do I have to consider it equal to 0,390*Do whatever L/Do is? thanks
 
Sort by date Sort by votes
Answer: consider 0,390*D.
See interpretation Number : VIII-1-89-121
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

victor6397
  • Question Question
Question about Ratcheting (ASME Sec. VIII Div.2)
Replies
6
Views
14K
victor6397
victor6397
R
  • Question Question
Exclusion From the Scope of ASME BPVC VIII-1 - water-based solution
Replies
4
Views
6K
goutam_freelance
goutam_freelance
jayinwww
  • Locked
  • Question Question
ASME Sec VIII Div 1 full pen weld on a mixer
Replies
4
Views
781
weldstan
weldstan
teokal
  • Locked
  • Question Question
Saddle calculations for ASME VIII Div.2 Pressure Vessel - paragraph 4.15
Replies
0
Views
2K
teokal
teokal
jayinwww
  • Question Question
Calculating Stress Ratio ASME B31.3 Figure 323.2.2A Note 6
Replies
0
Views
448
jayinwww
jayinwww

Part and Inventory Search

Sponsor

Back
Top