I am looking at putting a radio on a tower. The interface to the radio is fiber, but the only transmission in the area is copper (basic T-1). I was thinking may be a fiber t-1 modem on each end, but I am not sure. What about attenuation? The repeaters on the copper side should take care of the copper portion. Are there any products that would work? There is also the problem of power. You obviously cannot get AC power in a lot of places, so DC would be the rule.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Fiber to copper interface
- Thread starter mjwilli
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question
