Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

FEATURE BASED TRANSLATION FROM SOLIDWORKD

  • Thread starter Thread starter SVFC
  • Start date Start date
Status
Not open for further replies.
S

SVFC

Guest
WE ARE USING SOLIDWORKS. WE NEED A FEATURE BASED TRANSLATOR THAT WILL TRANSLATE PARTS AND ASSLYS TO PROE WITH FULL FEATURE TREE. IS THERE ANY SUCH PRODUCT AVAILABLE?



THANKS

SVFC
 
check out these guys - http://www.translationtech.com/

I think they were going to come out with a Solidworks translation engine
 
Status
Not open for further replies.

Similar threads

shanemolloy
  • Locked
  • Question Question
Replacing a component in an assembly based on excel
Replies
0
Views
377
shanemolloy
shanemolloy
Sidtha
  • Locked
  • Question Question
How to get the Balloon Position from CATIA V5 Drawings using VBA
Replies
1
Views
1K
looslib
looslib
engineeringspread
  • Locked
  • Question Question
Single Hole Pattern from sketch
Replies
1
Views
707
DesEng1986
DesEng1986
VanW
  • Locked
  • Question Question
Learning creo from SW, very basic questions
Replies
9
Views
1K
bartbrejcha
bartbrejcha
PhilKa
  • Locked
  • Question Question
Creo Macro for Supressing Features
Replies
1
Views
469
3DDave
3DDave

Part and Inventory Search

Sponsor

Back
Top