abdowurth
Mechanical
- May 2, 2012
- 1
We all now that the standard thread angle of a fastener is 60 degrees. I just want to know what will happen to the torque applied, tightening, and other forces, if we reduce this angle?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
fasteners thread angle
- Thread starter abdowurth
- Start date
- Status
Similar threads
- Locked
- Question
