Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Fanuc OM error

Status
Not open for further replies.
majstr

majstr

Mechanical
Joined
Feb 4, 2006
Messages
4
Location
SI
hello,
When I start the servo I have two errors:
401 servo error-VRDY OFF
414 servo error- X axis detect error
Did You have the same problem any time?
Thanks
 
Sort by date Sort by votes
The 414 error usually means that you have an axis disconnect. This error is very common when a cannon plug comes loose or an axis cable gets cut.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

D
  • Question Question
Drilling oversized and drilling undersized on Fanuc machine?
Replies
5
Views
7K
SamuelPrescott4
SamuelPrescott4
Thierry SEGUI
  • Locked
  • Question Question
Fanuc system variables
Replies
1
Views
531
enginesrus
enginesrus
Phillip_AE
  • Locked
  • Question Question
Amada software DR.ABE simulation Error EM 401 S
Replies
0
Views
165
Phillip_AE
Phillip_AE
luthau
  • Locked
  • Question Question
Z70 Absolute Position Error on M720 unit
Replies
1
Views
1K
luthau
luthau
angeldelangel
  • Locked
  • Question Question
616 ALARM EIL ERROR SENT BY AN MTU DIESEL ENGINE
Replies
0
Views
505
angeldelangel
angeldelangel

Part and Inventory Search

Sponsor

Back
Top