Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Family Table Instances in Column Model

  • Thread starter Thread starter Orion07
  • Start date Start date
O

Orion07

Guest
Hello,

Is it possible to show only the generic model (as opposed to family table instances) in a BOM? Or is it possible to remove the various family table instances in a BOM similar to a "remove duplicates" and just represent the generic? I have some sub-assembly instances that represent different orientations of parts but I don't necessarily need these instances in the BOM. Just one entry of the generic would be fine.

I'm using Creo/pro 5.0.

Thanks!
 
You must log in or register to reply here.

Similar threads

B
  • Locked
  • Question Question
with lookup_inst function variants change family table via parameters
Replies
1
Views
2K
3DDave
3DDave
D
Lost Model in Drawing
Replies
0
Views
5K
Den E
D
S
Obsoleting family table instances
Replies
0
Views
2K
sadrok-01
S
freerangequark
  • Locked
  • Question Question
Patterning Issue - Timing Belt Model
Replies
7
Views
1K
3DDave
3DDave
freerangequark
  • Locked
  • Question Question
Model Tree, tracking part identity
Replies
2
Views
2K
geesaman.d
geesaman.d

Part and Inventory Search

Sponsor

Back
Top