MikkoK
Industrial
- Jul 12, 2017
- 1
Hey,
I'm new to this forum and also not much experience with Creo.
In my model I'm trying to make this part sliding up and down depending of the position of the other parts. All my other moving parts are set as "Pin" - connection and they are working well. But when I'm trying to define this crucial part I run out of ideas. How to do it? I think solution is simple but still I'm unable to make it move properly.
I'm new to this forum and also not much experience with Creo.
In my model I'm trying to make this part sliding up and down depending of the position of the other parts. All my other moving parts are set as "Pin" - connection and they are working well. But when I'm trying to define this crucial part I run out of ideas. How to do it? I think solution is simple but still I'm unable to make it move properly.