Face milling error

[wedxza]

Hi

I have questions about setting the face milling by using the "point boundary" method.
As shown in the pic, there is no error when I used the "face boundary" method, but there is an error when i tried to define the square by selecting 4 points.

Thanks

http://files.engineering.com/getfil...a442-f14980689799&file=face_milling_face2.jpg

 

[markrief]

We need much more information to diagnose this - version, operation template, steps to get to this point.
Or call GTAC and let them go through it with you.

Mark Rief
NX CAM Customer Success
Siemens PLM Software

 

[wedxza]

Hi Mark, I was trying to learn using the point method. I might miss something when trying to set the workpiece up.
And I will contact the GTAC if I found anything.

Thanks