Get a load of this. End mills under .0005 diameter!
Manufacturing Freeware and Shareware
Manufacturing Freeware and Shareware
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Extremely small end mills
- Thread starter mrainey
- Start date
We cut 45 Rc H13 with 0.02" diameter ball mills and I thought it was pretty hot stuff. Oh well back to the drawing board.
That 0.0004 end mill blows my mind!!!!!!
Mrainey,
I use your ME Consultant software and it is very good. Thanks you for doing all that hard work and then sharing it for free.![[thumbsup]](/data/assets/smilies/thumbsup.gif "[thumbsup] [thumbsup]")
That 0.0004 end mill blows my mind!!!!!!
Mrainey,
I use your ME Consultant software and it is very good. Thanks you for doing all that hard work and then sharing it for free.
- Thread starter
- #3
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question