Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
exposed duct through wall 45 degree angle
- Thread starter DUMechEng
- Start date
stanlsimon
Mechanical
The sheet rock people can precut an eliptical hole in a piece of sheetrock, slide over the duct stub. It will require some coordination.
Otherwise put this note on the drawing:
BEAT TO FIT, PATCH TO MATCH.
Otherwise put this note on the drawing:
BEAT TO FIT, PATCH TO MATCH.
Yes we have had a few instances on a project where the duct was installed as shown on the mechanical drawings penetrating a sheetrock wall partition exposed to view. (Not a fire rated wall!) We took some measurements of the actual instalation and fabricated escutcheons as required.
The penetration was typical of any other non fire rated penetration exposed to view.
rogzog
The penetration was typical of any other non fire rated penetration exposed to view.
rogzog
- Status
Similar threads
- Question