Error while projecting to assembly

[Beatrice]

While trying to project a sketch on part in a sub. I get this error.

"Cross-part projection failed because the sketch is in a part which is adaptive in another assembly"

I have projected other sketches to this part without problems, and projected from this part. I have turned off every thing adaptive. Any suggestions?

 

[Algernon]

Based on the error message, the problem still sounds like an attempt to be adaptive in more than one place. Could you double-check the adaptivity flag? You might want to edit the part in place, go to Documentation Settings, and make sure the Adaptively Used in Assembly is unchecked in Modeling tab.