Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Error in Workbench: Element number 0 not defined

Status
Not open for further replies.
dwilly

dwilly

Mechanical
Joined
Jun 27, 2012
Messages
1
I am running a mechanical simulation in Workbench and get an error: "Element number 0 is not defined as part of the current model." This error appears right after ANSYS finishes processing all of the contact regions for the model. Any suggestions?
 
Status
Not open for further replies.

Similar threads

struclearner
  • Question Question
Modelling Tapped Bolted Joint by Line Body in ANSYS Workbench
Replies
0
Views
4K
struclearner
struclearner
IJR
  • Locked
  • Question Question
Workbench 19: Submodelling (?) error
Replies
0
Views
451
IJR
IJR
struclearner
  • Locked
  • Question Question
Reaction Force Distribution in ANSYS Workbench!
Replies
0
Views
1K
struclearner
struclearner
X
  • Locked
  • Question Question
ANSYS mechanical : How to read the dimensions which are defined as function of other dimensions in UGNX as parameters in ANSYS?
Replies
0
Views
1K
xinyu3liu
X
H
  • Locked
  • Question Question
how to apply triangular load on an area, in ANSYS Workbench static module
Replies
1
Views
3K
karachun
karachun

Part and Inventory Search

Sponsor

Back
Top