Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Epoxy FR4/FR5 A & B-basis allowables
- Thread starter laremise
- Start date
MIL-HDBK-17 is your best bet.
There was also an effort several years back, part of the AGATE program, to publish allowables for the common resin/matrix systems. These were considered "FAA Approved," if that applies to your program.
Sometimes the suppliers will do the allowables program, and will let you have access unless it is proprietary (and that is the usual case). Can't blame a design approval holder for wanting to retain the value of their investment.
There was also an effort several years back, part of the AGATE program, to publish allowables for the common resin/matrix systems. These were considered "FAA Approved," if that applies to your program.
Sometimes the suppliers will do the allowables program, and will let you have access unless it is proprietary (and that is the usual case). Can't blame a design approval holder for wanting to retain the value of their investment.
SWComposites
Aerospace
Who is the vendor for FR4/FR5? What fiber and type (tape/fabric) are you using?
- Status
Similar threads
- Locked
- Question
