Hi you!
this is my first entry and I am really helpless. I hope that maybe one of you can help me.
In my simulation there is a small cube, which is one part of a big work piece, but I hve no clue how I can "say" ansys that the front area is not the end of the cube. in my calculations the temperature and the residual stress should move ´"through" the areas.
Do somebody know the command for my problem?
it would be great. thanks a lot!
Nele
this is my first entry and I am really helpless. I hope that maybe one of you can help me.
In my simulation there is a small cube, which is one part of a big work piece, but I hve no clue how I can "say" ansys that the front area is not the end of the cube. in my calculations the temperature and the residual stress should move ´"through" the areas.
Do somebody know the command for my problem?
it would be great. thanks a lot!
Nele