Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

EN vs EBlock

Status
Not open for further replies.
akanakapally

akanakapally

Automotive
Joined
Feb 5, 2008
Messages
7
Location
US
Hi,

I am trying to convert a Abaqus input deck to ansys in Hypermesh. After doing the conversion my elements are defined using "EN" command. If I do the same conversion in another pc I get "EBLOCK". What is the procedure to obtain EN command instead of EBLOCK or vice versa in ansys (or hypermesh).
 
Status
Not open for further replies.

Similar threads

Tegguy
  • Locked
  • Question Question
ANSYS: Beam Elements vs Joint Stiffness?
Replies
11
Views
2K
Tegguy
Tegguy
shiraz883
  • Locked
  • Question Question
Different results in ANSYS 2021 vs ANSYS 2022
Replies
0
Views
494
shiraz883
shiraz883
PedroCarneiro22
  • Locked
  • Question Question
NFORCE vs FSUM
Replies
8
Views
1K
PedroCarneiro22
PedroCarneiro22
Lee.Conti
  • Locked
  • Question Question
Gap Condition vs Gap Element
Replies
0
Views
195
Lee.Conti
Lee.Conti
Vitkacy1989
  • Locked
  • Question Question
Contact with bolts - different results SHELL vs. SOLIDS
Replies
0
Views
991
Vitkacy1989
Vitkacy1989

Part and Inventory Search

Sponsor

Back
Top