Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

EN 12953-3

Status
Not open for further replies.
Fizza453

Fizza453

Mechanical
Jun 22, 2011
262
Dear All,

When using equation 13.1-3 of EN 12953-3, should the value of u be taken as 1.5% i-e 0.015 or 1.5?
Thanks in advance.

Nasir
Welding Engineer
DESCON ENGINEERING LIMITED
PAKISTAN
 
Replies continue below

Recommended for you

Sort by date Sort by votes
any advice regarding the above matter please???

Nasir
Welding Engineer
DESCON ENGINEERING LIMITED
PAKISTAN
 
Upvote 0 Downvote
The value of 'u' should be 1.5 for plain furnace. Please see the formula 13.3.1
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Klara.Sophi
  • Locked
  • Question
Required burst pressure in EN 13445-3:2021
Replies
1
Views
610
Klara.Sophi
Klara.Sophi
Deepak_johsh
  • Locked
  • Question
EN 13480-3 Flange Calculations 4
Replies
4
Views
4K
Christine74
Christine74
MoZBy
  • Locked
  • Question
EN 12953-6 / Required nominal volume tank
Replies
0
Views
174
MoZBy
MoZBy
mrmyagi
  • Question
Help with interpreting branches in EN 13445-3 annex C stress categorisation
Replies
0
Views
3K
mrmyagi
mrmyagi
ElCidCampeador
  • Question
Creep design - EN 13445
Replies
4
Views
7K
GD2
GD2

Part and Inventory Search

Sponsor

Back
Top Bottom