Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

elegant balance drawing note

Status
Not open for further replies.
Tmoose

Tmoose

Mechanical
Joined
Apr 12, 2003
Messages
5,636
Location
US
Does anyone have any notes that have worked particularly well specifying balance requirements?

It makes sense to me when ISO hole/shaft fits (H7,p6,etc) are specified to include a table with the fits on the drawing.
 
Status
Not open for further replies.

Similar threads

connectionman
  • Locked
  • Question Question
High Speed Shaft Balancing without 4-Run Balance Method
Replies
5
Views
582
connectionman
connectionman
Wizard_design
  • Locked
  • Question Question
Designing a Balanced Rotating Shredder
Replies
11
Views
818
electricpete
electricpete
Hesam267
  • Locked
  • Question Question
what are balance speed depend on???
Replies
8
Views
1K
Tmoose
Tmoose
geesamand
  • Locked
  • Question Question
Specifying two balance grades for the same part
Replies
1
Views
181
mmamini
mmamini
geesamand
  • Locked
  • Question Question
Balance criteria based on design vibration limits
Replies
2
Views
198
geesamand
geesamand

Part and Inventory Search

Sponsor

Back
Top