TonyCro
Mechanical
- Jan 12, 2005
- 23
thread340-256777
Following on from this earlier thread, I am also looking to replace our ageing and unsupported software with something I can link DC/AC motor/generator design created in solid-works - this is not an immediate purchase, more a toe in the water !
Ansoft Maxwell looks to have the capabilities, has anyone used it as I intend and are any there others to look at ?
many thanks
Tony.
Following on from this earlier thread, I am also looking to replace our ageing and unsupported software with something I can link DC/AC motor/generator design created in solid-works - this is not an immediate purchase, more a toe in the water !
Ansoft Maxwell looks to have the capabilities, has anyone used it as I intend and are any there others to look at ?
many thanks
Tony.