When applying the overstock it tends to pop off after the harness is routed or if you try and edit a curve while the harness is routed. It only removes a portion of the overstock and not necessarily in the area that's being edited. Is there a particular preference that should be set or a particular way to apply the overstock. it seems to be very stragith forward
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Electrical Routing Overstock
- Thread starter dwood
- Start date